We're SEARious about barbeques  

Problem:  Barbeque will either not light or when lit will not heat up much over 150 degrees. 

Solution:  Shut BBQ off - including the tank.  Disconnect the regulator from the tank - you should here a 'hiss & pop' noise.  Re-attach the regulator to the tank.  Making sure the BBQ Valves are off - slowly open the tank.  Now open one of the BBQ control valves and re-light as per normal.

NOTE: When you shut down the unit - turn the tank off first and let the BBQ blow out on it's own.  Then shut off the BBQ control valves.

RULE OF THUMB: Tank is First thing you turn ON and the First thing you turn OFF.              TANK ALWAYS FIRST!

Explanation of Problem: In all Barbeques manufactures after January 1st 1994, there was a new connection system put on them called QCC1 which is Quick Connect Coupling ( the large black nut that fits over the big brass threads on BBQ tanks. )  The tanks were also redesigned with this system to only release the full jet of gas when it determines it is properly hooked up.  When the tank is first opened, it will release a small jet of propane into the line to pressurize it.  Once the line has been pressurized the pressure-release valve will open and release the full jet of propane.  If the pressure required is not reached within a certain time, the valve will trip into a safety position and must be reset.   When this safety valve is tripped, it is referred to as a decompression.  Decompressions can also happen for no apparent reason, however the method to reset is the same regardless.  If your barbeque is frequently experiencing this problem check your hose and regulator for possible leaks in the system.  Spray all the connections with soapy water.  If bubbles start forming then you have a leak which may require the tightening of a connection or the replacement of the faulty parts. 

If you are concerned or unsure about this or anything else to do with your BBQ, contact us or your local dealer for more information.